Projektliste
Ausgewählte Beispiele unserer Arbeit
Nachfolgend ausgewählte Beispiele unserer Entwicklungen:
... Zurzeit in Bearbeitung ...
Schaltungsbeispiele aus dem Bereich Entwicklung:
| Device/circuit | Description | Datasheet/Specs |
| HV Linear Capacitive/High-Impedance load driver | ±200 Bipolar linear driver | Input: +/-10V Output: ±200V PS: ±15V BW: 100HZ |
| General purpose 4-Layer FPGA/µC board | Programmable functionality | FPGA (Spartan) µC (ATMEGA) |
| Small Buffer/Inverter board | Configurable, with or without amplification | PS: ±15V, BW: 1MHz |
| Floating bipolar 4kV/2kV HV switch | Based on Behlke Switch, switching from the -ve HV to half the applied HV. 25ns pulse width, driving up to 10nF capacitve loads | 4kV/2kV high side switch to drive low capacitive loads |
| Fast Pulse Pre-Amplifier | DC coupled high Gain, high BW, non-inverting fast pre-amplifier | Gain (in 50Ω): ~31 BW: 390MHz Max Input: 68 mV |
| 1mA Current source | Constant current driver for PT100 or similar low current sensors | PS: +6V, ±15V |
| simultaneous, 8Ch, 16/18-bit ADC sampler | Serial output, max throughput, when all channels active 200kSPS | PS: ±6V, ±15V
|
| USB 8Ch Relay driver | USB powered | |
| Power Supply 8V / 6A | Input: 24VDC, 52,8 Watt | |
| Fast, high gain, high BW, non-inverting DC Amplifier | 50 or 100 overall Gain | DC coupled, 50Ω I/O, PS: ±6V, BW: ~300MHz |
| Floating Bipolar 6kV fast HV switch | Based on Behlke switch | rep. freq. kHz |
| Linear CCD analog front end (CCD-AFE) | Analog front end for (industry standard) linear CCD array image sensors | PS: +6V, 78mA |
| 8Ch I2C switcher, driver | switching 8 logic level independently through I2C interface | |
| Various µC boards for different tasks/functions | µC board for different purposes: e.g. multi channel temperature monitoring, slow control / Interlock, Valve gate driver controller etc. | PS: +5V, +3.3V LCD, PB, RotEnc, etc. interfaces |
| 4Ch, I2C programmable 12-bit DAC with EEPROM | ||
| Log Amplifiers | up to 100dB input range | |
| Laser Monitor | 80MHz Laser Monitoring module, with discriminator to signal missing laser pulse(s) | input: ±5V, TTL output |
| HV Pulse extractor | 1kV | TTL output |
| High BW ADC driver board | DC coupled | PS: 5V |
| Pulse picker Trigger Generator | Extracting one single pulse from 80MHz laser signal, programmable with dead time | TTL |
| Pockels cell driver | 4kV pockels cell driver, triggered by a pulse picker/selector (also in house development) | HV pulse output |
| Low offset, Fast DC amplifier | PS: ±5V |
Schaltungsbeispiele der Elektronik-Werkstatt
| Schaltung | Beschreibung | Datenblatt |
| 4kV Hochspannung Netzgerät | Über IEEE Bus steuerbar hochauflösendes Digitalpotentiometer digitale I/U Anzeige | 4kV/20mA, Optional hochlegbar bis 3kV, Umpolschalter |
| Mathe-Einheit |